SKF PER.GE-40-ES y-bearing (insert bearing)
- Brand
- SKF
- Category
- Bearings
- Subcategory
- Y-bearing (insert bearing)
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
SKF PER.GE-40-ES belongs to y-bearing (insert bearing), part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PER.GE-40-ES and any equivalents.
The SKF PER.GE-ES is a Y-bearing insert with an extended inner ring that locks to the shaft using set screws. It fits split or pillow block housings and provides straightforward, sturdy support for drive shafts. The sealed design suits areas with dust or moderate humidity.
The part number breaks down into three parts: PER denotes the insert series with extended inner ring and set screws, GE identifies the seal type, and ES marks an execution variant. The number in the middle refers to the shaft diameter. Common sizes in the series include PER.GE-20-ES, PER.GE-25-ES, PER.GE-30-ES, PER.GE-35-ES, and PER.GE-40-ES. Always check the technical data sheet for the exact dimensions of each item.
Typical applications include belt conveyors, packaging lines, mixers, fans, and transmission equipment in food, textile, ceramic, and aggregate plants. Because the insert mounts in a split housing, it can be replaced without fully dismantling the shaft, which helps reduce downtime during maintenance.
When choosing an insert, confirm the shaft diameter and the housing type. The GE seal keeps contaminants out; in very dirty conditions, consider adding extra sealing. During installation, clean the shaft, apply the recommended lubrication, and tighten the set screws with even torque. Check alignment to prevent axial loads. Careful mounting helps extend service life and reduce vibration.
SKF Y-bearings can be interchanged with other brands that follow the same dimensional standard. Before replacing, compare bore diameter, width, and fixing method. The PER.GE-ES series may substitute equivalent inserts from other manufacturers, but verify tolerances and sealing first. Avoid mixing brands in the same equipment without checking internal clearance.
To request a quote, send the full part number by WhatsApp or email. Include the quantity and, if known, the housing type. Our team can suggest equivalents and help you select the right variant.
Dimensions
Dimensions and tolerances: Message us the part number on WhatsApp and we'll verify its dimensions and version with the manufacturer's datasheet.
Frequently asked questions
- What does the PER.GE-ES code mean?
- PER stands for insert with extended inner ring and set screws; GE indicates the seal type; ES is an execution variant. The middle number refers to the shaft diameter. For each size, consult the technical data sheet or contact us.
- Can this bearing be used with other brands?
- Yes, SKF Y-bearings follow dimensional standards that allow interchange with other brands. Always verify bore diameter, width, and fixing type before replacing. If unsure, send us the part number and we will advise.
- How is the SKF PER.GE-ES Y-bearing mounted?
- It is mounted in split or pillow block housings. Clean the shaft, apply lubrication, and tighten the set screws with uniform torque. Verify alignment to avoid axial loads. Correct mounting helps extend bearing service life.