SKF PER.FHR206-20 y-bearing (insert bearing)

SKF PER.FHR206-20 belongs to y-bearing (insert bearing), part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PER.FHR206-20 and any equivalents.

The SKF PER.FHR is a Y-bearing insert: a bearing with a spherical outside surface that locks onto the shaft with set screws and seats inside a split or pillow block housing. It suits equipment where perfect alignment is hard to hold and where the bearing should be simple to fit and swap out. MR Industrial Accessories LLC supplies this line and helps buyers match the right variant to the job.

Reading the code helps you order the right piece. PER is the series; FHR marks the design with the spherical outer ring and set screw locking. The three digits that follow give the size class by shaft diameter: 205, 206, 207 or 208. A hyphenated suffix then states the bore in inches, so -16 means a 1 inch bore, while -19, -20, -22 and -24 cover other inch bores. PER.FHR205-16 therefore fits a 1" shaft, and PER.FHR206-20 fits a 1 1/4" shaft. Quote the full number so nothing gets mixed up.

You will find these inserts on belt conveyors, grain elevators, flour mills, feed plants, sand washers, centrifugal pumps and fans, as well as in meat processing machinery and chemical plant equipment. Because the bearing is sealed, it holds up in dusty, damp areas and where washdowns are routine, as long as the seal type matches the conditions.

Selection comes down to three things: shaft diameter, whether the load is radial, axial or combined, and the working environment. Sealing deserves close attention, since these bearings are offered with single or double lip seals and, in some cases, extra protection. Grease may be lithium or synthetic, and many units arrive pre-lubricated from the factory. When fitting, line up the housing properly and tighten the set screws to the specified torque with a torque wrench; forcing the bearing on can ruin the seals and shorten its life.

Interchange is possible with other brands built to the same dimensional standard, but the suffixes do not always line up. Check bore, outer diameter, overall width and locking method before substituting, and look at the seal arrangement and load capacity too. MR Industrial Accessories LLC can point you to options in its range while keeping to the original equipment requirements. Send the complete part number by WhatsApp or email for a quote, or share the dimensions and we will help you identify the replacement.