SKF GE 10 E spherical plain bearing
- Brand
- SKF
- Category
- Bearings
- Subcategory
- Spherical plain bearings and rod ends
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
SKF GE 10 E belongs to spherical plain bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for GE 10 E and any equivalents.
Rod ends and spherical bearings in the SKF GE E line use a spherical sliding surface to carry radial loads while allowing the shaft and housing to move out of line. Hydraulic cylinders, steering linkages and lifting mechanisms are typical places where this angular freedom is needed. The line is one of the brands MR Industrial Accessories supplies, and the examples on hand start at a 4 mm bore and go up to 12 mm.
Reading the code is straightforward. GE tells you it is a radial rod end with a spherical sliding surface. The figure in the middle is the bore diameter in millimeters, so GE 4 E takes a 4 mm shaft. The trailing E marks a design variant whose cage or seal arrangement changes from one version to the next. Because the number drives the size, the range covers small-diameter shafts used in precision work.
You will find these parts in automotive, agricultural, metalworking and hydraulic equipment. Steering cylinders, suspension arms, tipping linkages and transmission systems that oscillate while the two ends sit at an angle are common homes for them. They take radial and axial loads well in tough conditions, as long as the size and the sealing suit the job.
Sizing starts with the shaft diameter, the radial and axial load, and how much oscillation the joint must allow. The housing and shaft have to line up precisely at installation, since misalignment speeds up wear. Grease or oil is normally required depending on the application, and many versions carry seals that hold lubricant in and keep contaminants out. Confirm radial clearance and housing tolerance before fitting.
Alternatives exist. Any brand that follows the same dimensional designation, including GE..E series from European or Asian makers, can be considered. Tolerances and surface treatments are not identical across suppliers, so compare the technical data before swapping a bearing out. MR Industrial Accessories can review compatibility with the equipment you run.
Send the full code through WhatsApp or email to request a quote. The team answers quickly, helps confirm the correct part and can point you to equivalents when needed.
Dimensions
Dimensions and tolerances: Message us the part number on WhatsApp and we'll verify its dimensions and version with the manufacturer's datasheet.
Frequently asked questions
- How do I read the GE 4 E code?
- GE stands for a radial rod end with a spherical surface, 4 is the bore diameter in millimeters, and E is a design variant with a particular cage or seal. It follows standard SKF nomenclature for small spherical bearings.
- Do these bearings need lubrication?
- They do, at intervals that depend on the application. Certain versions have seals that keep grease in and contaminants out. The equipment manual is the best guide for how often to lubricate.
- Can a GE E spherical bearing be replaced by another brand?
- Yes, if the dimensional designation matches and the tolerances work together. Materials and treatments differ between makers, so check the specifications and ask MR before you replace one.