SKF 15X24X7 HMSA10 V1 radial shaft seal

SKF 15X24X7 HMSA10 V1 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 15X24X7 HMSA10 V1 and any equivalents.

For rotating shafts, the SKF HMSA10 V line covers single-lip seals with a spring. They hold lubricant in place and block dirt from entering gearboxes, pumps, motors and reducers. MR Industrial Accessories supplies this brand, and our team can help you match a seal to your equipment when the marking is unclear.

Reading the code takes a moment and saves ordering mistakes. Take 7X16X7 HMSA10 V1: the first three figures are the bore, the outside diameter and the width in millimeters. HMSA10 is the series, a single lip with a spring. The trailing V points to the elastomer, typically nitrile rubber (NBR), which handles mineral oils and moderate heat. The same pattern holds for 10X19X7 HMSA10 V1 and 70X90X7 HMSA10 V1, so once you know the order of the figures you can identify any size in the range.

These seals turn up in reducers and motors in food processing, centrifugal pumps in chemical service, drivelines in automotive work and farm equipment. Mining operations rely on them too, where dust and water put sealing under pressure. The spring keeps the lip in steady contact with the shaft, which absorbs minor misalignment and surface wear. Under vibration or moderate speeds, the HMSA10 V series holds back oil and particles.

Selection comes down to a few checks: shaft and housing dimensions, the lubricant in use and the temperature range. During installation, cleanliness matters most, since a burr or a speck of grit can score the lip and start a leak. Coat the lip with the same oil the machine runs before pressing it in, and use a proper driver so the seal goes in square. Shaft and housing need to line up; too much eccentricity wears the lip faster. A worn shaft may call for a repair sleeve. Handled this way, the seal lasts longer and unscheduled stops become less frequent.

Interchange is possible with seals from other makers that share the same dimensions and lip style. Confirm the elastomer and spring suit the fluid and temperature before substituting. When in doubt, send us the equipment brand and part number. MR Industrial Accessories will advise you so the replacement works safely.

For a quote, message us on WhatsApp with the full part number. If it is not readable, send the shaft and housing dimensions plus what the application is. Our technical team replies with the right option.