SEALMASTER SSF2S-110 flange bearing 2 holes
- Brand
- SEALMASTER
- Category
- Bearing housings
- Subcategory
- Y-bearing unit
- Series
- SSF2S 100
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
SEALMASTER SSF2S-110 belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SSF2S-110 and any equivalents.
The SEALMASTER SSF2S 100 series is a two-bolt flange Y-bearing unit that pairs a cast iron housing with a factory-aligned and pre-lubricated insert ball bearing. It mounts flat against a surface with two bolts and is designed for mainly radial loads. MR Industrial Accessories supplies this series in multiple shaft sizes.
The part number breaks down into two parts: the letters indicate the housing style and flange arrangement, while the three-digit number specifies the shaft size the insert is machined for. When requesting a quote, always provide the complete part number so we can identify the exact variant you need.
Typical applications include belt and roller conveyors, packaging lines, mixers, blowers, exhaust fans, bucket elevators, and milling equipment. The flange design also suits washing systems, cold rooms, and water treatment plants, where the unit can be bolted to sheet metal or a frame without machining a housing bore. Food, chemical, and aggregate plants often choose these units because the insert is straightforward to replace during maintenance.
Selection depends on shaft diameter, load type, and operating environment. In dusty or wet conditions, an insert with enhanced sealing is recommended; where misalignment is present, a self-aligning insert that accommodates the shaft inside the housing is preferable. During installation, rest the flange on a clean, flat surface, tighten both bolts evenly, and verify the shaft turns freely. Check lubrication and internal clearance according to the insert; if unsure, ask by part number.
Two-bolt flange housings with inserts are interchangeable across brands by shaft size and mounting configuration, not by part number. Each manufacturer uses its own nomenclature, so equivalence is determined by comparing shaft diameter, hole spacing, fastening type, and sealing. The compatible alternative is found within the same family. MR Industrial Accessories can identify that equivalent based on the part number or model you provide.
MR Industrial Accessories supplies SEALMASTER and other lines of housings and insert bearings, and manufactures split plummer block housings, ANSI chains, and sheaves. Send your part number or equipment model via WhatsApp for a quote on the correct variant, and we can also suggest a compatible alternative if needed. We also assist with mounting, sealing, and lubrication so the unit runs aligned and performs as expected.
Dimensions
- Bore
- 5/8 in
Frequently asked questions
- How do I determine the shaft size for an SSF2S housing?
- The numeric suffix of the part number indicates the shaft size the insert is machined for. Match that number with your shaft diameter and the distance between the flange holes. If you are unsure, send us the full part number or the equipment model and we will confirm the variant.
- Can I replace just the insert bearing?
- Yes. In Y-bearing units with an insert, the housing and bearing are separate components, so the insert can be replaced without changing the flange, provided the housing bore is in good condition. The shaft size and fastening type of the original insert must be matched.
- What should I consider during mounting?
- Rest the flange on a clean, flat surface, tighten the two bolts evenly, and check that the shaft turns freely and aligned. In dusty or damp environments, choose an insert with suitable sealing. If the equipment operates with misalignment, a self-aligning insert is recommended.