SEALMASTER SLS-124 insert bearing

SEALMASTER SLS-124 belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SLS-124 and any equivalents.

The SEALMASTER SLS 100 series insert bearing is a single-row bearing with an extended inner ring, made to sit in split plummer block housings and mounted units. It supports a rotating shaft with simple alignment and axial fixing, either by set screws or a collar. This insert is a common replacement item in power transmission, conveying and process equipment, and it is chosen by shaft diameter and by the housing in which it is seated.

Reading the code starts with the number after the hyphen, which gives the shaft diameter the insert fits. In the examples SLS-108, SLS-110, SLS-112, SLS-114, SLS-115, SLS-116, SLS-118 and SLS-119, each code stands for a different shaft size in the same family. The SLS prefix tells you the insert type; the numeric suffix tells you the size. For a replacement, the full code is what matters.

You will find these inserts on belt and roller conveyors, mixers, mills, bucket elevators, industrial washers and process equipment in food, chemical and aggregate plants. Because the housing that holds them is normally bolted to the structure, the insert is the part that gets changed when play, noise or lubricant loss shows up.

Selection begins with the shaft diameter and the housing: the housing must accept the SLS 100 series. Look at the seal as well, since it keeps lubricant in and dust and water out. When fitting the insert, do not strike the outer ring; press it into place, tighten the set screws onto the shaft and check housing alignment before start-up. Correct lubrication and alignment help the assembly last.

For equivalences, insert bearings are compared between brands by shaft size, fixing method and seal arrangement, not by the commercial code. An insert from another brand with the same size and fixing may interchange, but check the inner ring width and the seal type. If the equipment uses a housing from another line, MR Industrial Accessories can name the alternative that matches the code on the part.

To replace an SLS 100 insert, send the complete code from the bearing, or the shaft diameter and housing type, by WhatsApp or email. We will quote it, and if you need a variant not listed, send the model and we will point you to the corresponding option.