SEALMASTER SFTMH-20RT flange bearing 2 holes

SEALMASTER SFTMH-20RT belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SFTMH-20RT and any equivalents.

A two-bolt flange mounted Y-bearing unit from the SEALMASTER SFTMH-T line, supplied with an insert bearing. It holds and centers a rotating shaft against a flat surface, and the flange layout keeps alignment and mounting straightforward without any machining of the base. MR Industrial Accessories LLC supplies this line and helps buyers match the right variant to their shaft size and load conditions.

Reading the code is the fastest way to order. SFTMH points to the flange housing family that takes an insert bearing; the digits that follow give the nominal shaft size; RT describes how the insert is sealed and locked. In SFTMH-20RT, then, 20 is the shaft and RT is that construction variant. Need a different size? Send the full part number and we will quote the matching reference.

Typical duty covers belt conveyors, packaging lines, mixers, blowers, centrifugal pumps and process equipment in food, chemical and aggregate plants, usually on low to medium speed drive shafts. Because the two bolts sit on the flange, the unit can be fixed to folded sheet metal or profile structures, which keeps installation work low compared with other support styles.

Selection comes down to three things: shaft diameter, the nature of the load (radial, axial or a combination) and the surroundings — dust, water or frequent washdowns. The insert seal is what decides how well grease stays in and contamination stays out. On the job, set the flange on a clean, flat surface, tighten the bolts in a cross pattern, and confirm the shaft turns freely by hand. Proper lubrication and careful alignment are what keep the insert bearing running.

Housings like this interchange across brands by dimension: shaft diameter, hole spacing and flange diameter, plus the locking style of the insert. MR Industrial Accessories LLC points out the compatible option within the lines it carries and can produce a made-to-measure housing when required. Send the part number or the housing measurements and you will get a prompt reply.

One last check before ordering: look at the shaft itself. A worn or burred diameter speeds up insert wear and adds noise. On equipment that vibrates, verify flange bolt tightness and axial play from time to time. With SFTMH-20RT or with the measurements of the housing you are replacing, our team will quote the reference through WhatsApp and walk you through mounting.