SEALMASTER SFC-209TMC piloted flange bearing

SEALMASTER SFC-209TMC belongs to piloted flange bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SFC-209TMC and any equivalents.

The SEALMASTER SFC-T series piloted flange bracket with insert bearing is a mounted assembly that pairs a cast housing with a ball insert bearing, designed to bolt onto a flat face. It is used when the shaft runs perpendicular to the mounting plane and the pilot centers the assembly. It suits simple drives that need rigid fastening and quick insert replacement.

The SFC-T code breaks down as follows: SFC denotes the four-bolt piloted flange bracket, T indicates the housing variant, and the three-digit number that follows corresponds to the insert bearing size. The MC suffix at the end specifies the insert sealing and fastening configuration.

In US plants, these brackets are found in belt and chain conveyors, mixers, screens, bucket elevators, packaging lines and water treatment equipment. They also appear in food processing, where the flange simplifies washing and disassembly, and in aggregate or cement operations, where dust requires dependable sealing. As a piloted flange, the assembly centers in the housing and absorbs moderate radial and axial loads.

Selection depends on shaft diameter, the insert fastening method on the shaft, and the sealing needed for the environment: a single contact seal for clean service, or tighter seals for dust or frequent washdown. During installation, set the flange on a flat, clean surface, tighten bolts in a cross pattern, and verify shaft alignment with the plane. Lubricate the insert according to the duty cycle and check axial clearance before start-up.

SFC-T series dimensions match those of other piloted flange bracket lines on the market when shaft diameter, pilot and hole spacing align. Interchangeability between brands is set by those dimensions and the insert type, not by the commercial part number. To replace an existing bracket, send the dimensions or the equipment part number and we will identify the compatible alternative.

MR Industrial Accessories supplies the SEALMASTER line and also manufactures split plummer block housings, ANSI roller chains and sheaves. If you need an SFC-T series size not listed, contact us on WhatsApp or by email with the part number or model: we will quote it and suggest a compatible alternative.