SEALMASTER MFCH-24T piloted flange bearing
- Brand
- SEALMASTER
- Category
- Bearing housings
- Subcategory
- Y-bearing unit
- Series
- MFC-T
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
SEALMASTER MFCH-24T belongs to piloted flange bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for MFCH-24T and any equivalents.
A piloted flange mounted bearing unit, the SEALMASTER MFCH-24T belongs to the MFC-T series. It carries rotating shafts in equipment where the housing bolts to a machined face and the pilot registers the unit in place. Buyers who already work with this series will recognize the code; those replacing a worn unit can send the number and let our team confirm the match.
Read the code in blocks: MFC marks the family of piloted flange housings supplied with an insert bearing, H identifies the housing design, 24 gives the nominal shaft diameter, and the trailing T shows the mounting variant. Quoting the full designation avoids confusion with similar references in the same family.
Typical duty covers belt conveyors, mixers, blowers, centrifugal pumps and packaging lines. Food, chemical, cement and aggregate operations are common homes for these units, since dust, moisture and washdown are part of daily life there. Mounting on sheet metal or cast iron is straightforward because the pilot provides a centering fit that takes some of the work out of shaft alignment.
Selection comes down to three inputs: shaft diameter, the nature of the load (radial, axial or combined), and the surrounding environment. Where dust or liquid is present, a reinforced seal is the sensible choice. Running at elevated temperature calls for a check on lubrication and internal clearance. At installation, the flange face should be clean and flat, bolts tightened in a cross pattern, and the shaft spun by hand before the equipment starts.
Housings from different manufacturers can be swapped when flange dimensions, pilot diameter and shaft diameter line up. Catalog codes alone are not enough for that comparison, so verify the mounting dimensions and how the insert is fastened. Our team can review your measurements and point to a compatible alternative if the original reference is not what you need.
Send the code MFCH-24T, or simply the shaft diameter, through WhatsApp or email. We answer promptly and can also advise on sealing, lubrication and mounting so the unit performs as intended.
Dimensions
- Número de producto
- 35144
- Bore
- 1 1/2 in
Frequently asked questions
- How is the MFCH-24T code broken down?
- MFC is the series of piloted flange housings with insert bearing. H indicates the housing design, 24 is the nominal shaft diameter, and T is the mounting variant. Quote the complete code to confirm the exact reference.
- Where is this housing typically installed?
- Conveyors, mixers, blowers, pumps and packaging lines are common applications, along with other equipment that uses rotating shafts. The pilot centers the assembly, which helps with alignment when the flange mounts to sheet metal or cast iron.
- What do I need to send for a quote?
- The part number MFCH-24T or the shaft diameter is enough to get started. Reach us on WhatsApp or by email, and if a variant is required we can look into the options with you.