REXNORD ZPS6415F flange bearing 4 holes

REXNORD ZPS6415F belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for ZPS6415F and any equivalents.

Rexnord ZP6000 series 4-bolt flange housings are mounted units that pair an insert bearing with a flange housing. They secure drive shafts to flat surfaces. The four bolt holes hold the unit in place and keep the shaft at a right angle to the mounting plane. This design is useful when a pillow block housing will not fit. MR Industrial Accessories LLC supplies these housings and quotes them by part number via WhatsApp or email.

The ZP6000 series code breaks down into parts. The letters ZPS denote a four-bolt flange housing. The four digits that follow specify size and configuration within the series. The letter F at the end completes the reference. This explains why part numbers such as ZPS6303F, ZPS6311F and ZPS6515F exist side by side: only the numeric block changes, not the unit type. The central number determines shaft size and housing dimensions. Provide the full part number and we will identify the exact variant.

These flange housings are common in belt and screw conveyors, mixers, blowers, centrifugal pumps, packaging lines and water treatment equipment. They suit installations where the shaft must be supported on a plate or frame and where lubrication points are hard to reach. The four-bolt flange spreads the load across the mounting surface and lets you remove the unit without dismantling the entire shaft.

When selecting a housing, consider shaft diameter, the shaft fixing method the unit accepts, the sealing needed for the environment (dust, water, washdown) and the lubrication schedule. During installation, place the flange on a flat, clean surface, tighten the four bolts in a cross pattern and verify shaft alignment before start-up. A flange that is not seated properly creates axial load and reduces insert bearing life.

For interchangeability, mounted flange units are matched by shaft size, hole pattern and insert type rather than by brand-specific codes. If your equipment uses another brand, send us the code stamped on the housing or the mounting dimensions and we will identify a compatible option from the ZP6000 series. The nomenclature does not have to match; what matters is the geometry.

If you need a part number that is not listed, contact us on WhatsApp with the model or the shaft dimensions and the distance between holes. MR Industrial Accessories LLC will quote the Rexnord housing you require and respond promptly.