REXNORD ZEPS5085MM pillow block bearing

REXNORD ZEPS5085MM belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for ZEPS5085MM and any equivalents.

The Rexnord ZEPS line covers floor-mounted housings built to carry rotating shafts in power transmission setups. This style of housing suits arrangements where the bearing sits on a base and the shaft runs parallel to the floor, leaving room to line up and bolt down the assembly. MR Industrial Accessories LLC supplies this line, with options across several shaft sizes and sealing arrangements.

Reading the code helps you order the right piece. ZE stands for the floor-mounted housing itself, while P and S describe how the unit is sealed and locked. The digits that follow point to the series and size, so ZEPS2035MM, ZEPS2040MM and ZEPS2045MM step up in shaft diameter as the number grows: 2035, 2040 and 2045 are separate commercial sizes inside one family. The MM ending identifies the sealing system and mounting variant. Series 2000, 5000, 6000 and 9000 each gather housings of different capacity and use, and every series keeps its own numbering pattern.

You will find these housings on belt and roller conveyors, bucket elevators, mixers, mills, screens and other process equipment in food, chemical and aggregate plants. They also turn up on industrial fans and horizontal-shaft centrifugal pumps, as long as the base allows the assembly to be anchored and leveled. Humid or dusty sites call for a sturdy housing and dependable sealing.

Selection starts with shaft diameter and load type: radial, axial or a combination of both. Match the seal to the surroundings, since dust, water or frequent washdown may call for labyrinths or tighter lip seals. Keep lubrication compatible with the bearing and renew it according to the duty cycle. When installing, set the housing on a flat, rigid surface, bring the shaft into line with the driven equipment and tighten the mounting bolts evenly. The clearance built into a mounted bearing absorbs minor misalignment, though a straightedge or dial indicator check is still worthwhile.

Rexnord and Link-Belt use shared nomenclatures in the mounted bearing range, and many housing numbers cross over to other brands. Swapping is not automatic, because center height, tolerances and sealing differ from one unit to another, so compare the full designation rather than the shaft diameter alone. Send the original equipment number or the shaft size and we will point you to the compatible option in the Rexnord line we supply, including guidance on series 2000, 5000, 6000 or 9000 based on load and working conditions.