REXNORD ZBS6065MM flange bearing 4 holes

REXNORD ZBS6065MM belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for ZBS6065MM and any equivalents.

Rexnord ZBS 4-bolt flange bearings pair an insert bearing with a square or round flange housing. They secure a shaft to a wall, sheet metal panel or structural frame, with the shaft running perpendicular to the mounting surface. These units handle radial loads along with moderate thrust in the axial direction. MR Industrial Accessories supplies this line and helps you match the right variant to your shaft size and mounting arrangement.

Reading a ZBS part number is straightforward once you know the blocks. The ZBS prefix marks the flange housing family. The four digits in the middle tie together the shaft size and the insert style. The MM suffix at the end covers the sealing arrangement and how the unit is put together. In the 2000 series, part numbers like ZBS2080MM and ZBS2085MM use those middle digits for the nominal shaft diameter and insert bearing series. The 5000 series, including ZBS5040MM and ZBS5055MM, follows the same pattern on a different dimensional base. Use the manufacturer's interchange table to decode each number precisely.

You will find these flange units on belt and roller conveyors, bucket elevators, mixers, blowers, centrifugal pumps and other process equipment in food, chemical and aggregate plants. The 4-bolt flange mounts to folded sheet metal or profile structures, and the shaft exits perpendicular to the mounting face. That layout makes alignment simpler on equipment where the housing bolts directly to a frame.

Start your selection with the shaft diameter and the load type. If radial load dominates, a standard unit will usually do. When axial thrust is present, check the insert's capacity. Sealing matters in dusty, wet or washdown environments; versions with a contact seal and an extra lip do a better job of keeping lubricant in place. During installation, tighten the four bolts in a cross pattern with a torque wrench so the flange does not distort. Confirm the shaft turns freely, then grease the insert according to your duty cycle. The bearing's internal clearance absorbs slight angular misalignment, but correct it before startup when possible.

Rexnord and Link-Belt share nomenclature across many mounted bearing lines, and other makers offer equivalent units under their own part numbers. Interchange depends on shaft diameter, insert type, flange hole spacing and sealing. When you ask for an alternative, include the complete part number and your operating conditions so load capacity and mounting style can be compared without risking a mismatch.

Need a Rexnord flange bearing? Send the full part number and shaft size through WhatsApp or email. MR Industrial Accessories will reply promptly with a quote and point you to the variant that fits your equipment.