REXNORD KLPSS223 pillow block bearing

REXNORD KLPSS223 belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for KLPSS223 and any equivalents.

The Rexnord KLP-SS200 series covers foot-mounted pillow blocks that hold the bearing and anchor it to the machine frame, with alignment and sealing handled at the factory. They suit rotating shafts on conveyors, elevators, mixers and process lines, and are picked by shaft size and load type. MR Industrial Accessories supplies them and helps you land on the right part number.

Reading the code tells you most of what you need. KLP marks the split pillow block family, SS is the sealing variant, and the last three digits give the shaft size. That is how KLPSS212, KLPSS216 and KLPSS224 sit in one series: the housed diameter changes while the mounting geometry stays the same. If your equipment lists a similar number with a different suffix, send it over and we will point you to the compatible option.

Typical duty includes belt and chain conveyors, bucket elevators, mixers, dryers and continuous process equipment. Food and beverage plants use them where washdown-resistant sealing matters, and chemical or water treatment operations favor them for humid conditions. The foot base bolts straight to stringers or sheet metal beds with no extra machining.

Selection starts with the shaft diameter, then the load type: pure radial or with axial thrust. The SS seal keeps out dust and splashes, so prioritize it where water or particles are present. On installation, set the base on a flat surface and align both units before tightening the bolts, since misalignment shortens bearing life. Lubricate to the duty cycle and check axial clearance before startup.

Because these units follow Rexnord's own nomenclature, swapping across brands is not a direct match. Compare shaft diameter, hole spacing, center height and sealing type instead. An equivalent from another manufacturer often exists, but confirm it against the data sheet. Send the original part number or your mounting dimensions and we will identify the closest fit.

For a KLP-SS200 series pillow block, message us the full part number: KLPSS212, KLPSS216, KLPSS219, KLPSS220, KLPSS222, KLPSS223 or KLPSS224. We will quote promptly, and if you need a different sealing variant or size, we will guide you to the right solution.