V-belt Optibelt XPZ 1060

OPTIBELT XPZ 1060 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for XPZ 1060 and any equivalents.

When you pull a worn belt off a drive, the marking on the back is the fastest way to identify what goes back on. This page covers the Optibelt XPZ 1060, a cogged narrow V-belt in the Super X-Power M=S series. Read your old belt's back first, then compare it against the profile and length below.

The Optibelt XPZ 1060 is a cogged narrow V-belt with an XPZ profile and a length of 1060 mm. The marking on the back of your existing belt should show the profile and the length in the same form; if the profile reads XPZ and the length matches, this belt is the direct size to replace it. If the marking is worn or unreadable, measure the belt and note the profile from the pulley groove instead.

Cogged narrow V-belts are used where a standard wrapped belt would run hotter or slip under load, so the cogged construction matters when the drive was built around it. Fit the new belt to the same groove profile and length as the original, and check the pulleys for wear, alignment and any debris before you install it. On drives running more than one belt, replace the full set at the same time so the load stays evenly shared.

The same size is also listed under Gates XPZ 1060, so if your marking points to that brand, the Optibelt XPZ 1060 is the matching size we carry. Send us the part number from the back of the belt, or the profile and length if the marking has worn off, and we will confirm the right belt or suggest an equivalent.