V-belt Optibelt XPC 2800

OPTIBELT XPC 2800 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for XPC 2800 and any equivalents.

This is an Optibelt XPC 2800 cogged narrow V-belt from the Super X-Power M=S series. For buyers, the key selection data is in the part number: the XPC profile and the 2800 mm length. Match both to the belt you are replacing.

The XPC profile identifies the cross-section and the 2800 mm value gives the datum length. When you read the marking on the back of an existing belt, confirm that it shows the same profile and length before you order. If the old belt is worn or the marking is unreadable, measure the length along the belt path and check the pulley groove width against the XPC profile.

This is a cogged narrow V-belt, also called a wedge belt. The cogged construction is typical for drives where the belt must flex around smaller pulleys. On a multi-belt drive, replace all belts in the set at the same time so the load stays evenly distributed. Inspect the pulleys for wear, alignment and groove condition while the belts are off.

To request a quote, send the part number XPC 2800 and the quantity you need by WhatsApp or email. If you are unsure whether this is the correct belt, include the profile and length from the old belt, plus a photo of the marking on the back. Our team can confirm the right belt or suggest an equivalent.