V-belt Optibelt XPA 850 XEP

OPTIBELT XPA 850 XEP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for XPA 850 XEP and any equivalents.

The Optibelt XPA 850 XEP is a cogged narrow V-belt in the Super XE-Power Pro M=S series, with an XPA profile and a length of 850 mm. It is a raw-edge wedge belt with a molded cog pattern on the underside, which is what you would expect to find on compact, high-ratio drives. We carry this belt for maintenance, engineering and purchasing teams across the United States, Canada, Mexico and South America.

The fastest way to confirm you are ordering the right belt is to read the marking on the back of the old one. Look for the profile and the length together, shown here as XPA and 850 mm, and match them against the Optibelt XPA 850 XEP before you request a quote. If the back of the belt is worn, glazed or rubbed away, take the measurement from the drive instead and check the profile against the pulley groove width.

Cogged narrow V-belts like this one are commonly used where a standard wrapped belt would run too hot or slip on a small diameter pulley. When you replace one, inspect the pulleys for wear, rust and debris in the grooves, and check the alignment and tension of the drive before the new belt goes on. If the drive runs more than one belt, replace the full set at the same time so the load stays evenly shared.

Send us the part number XPA 850 XEP, or a photo of the marking on the belt and the pulley diameters, and our team will confirm the belt for your drive. We reply promptly by WhatsApp or email with a quote, and we can help confirm the correct belt or suggest an equivalent.