V-belt Optibelt XPA 1357 XEP

OPTIBELT XPA 1357 XEP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for XPA 1357 XEP and any equivalents.

The Optibelt XPA 1357 XEP is a cogged narrow V-belt in the XPA profile with a 1357 mm length. To match it to the belt being replaced, confirm the profile and length on the old belt before ordering. This belt is used on industrial drives where a narrow V-belt is specified.

Start by reading the marking on the back of the belt you are replacing. Look for the profile and length: the XPA profile and 1357 mm length identify this Optibelt belt. If the old belt shows a different profile or length, this is not the correct replacement. The Super XE-Power Pro M=S series is a cogged narrow V-belt construction, which can run on smaller pulleys than a standard wrapped belt of the same profile.

If the marking is worn or unreadable, measure the outside length with a tape or compare the old belt to the drive pulley grooves. The XPA profile is a narrow wedge cross-section. The 1357 mm length is the datum length for this belt. When you request a quote, send the full part number XPA 1357 XEP, or the profile and length from the old belt, and our team will confirm it or suggest an equivalent.

For drives with multiple belts, replace all belts in the set at the same time to keep load sharing even. Inspect pulleys for wear, alignment and debris before installing the new belt. A cogged narrow V-belt like this Optibelt XPA 1357 XEP is suited to drives that need a compact, high-capacity belt.