V-belt Optibelt XPA 1132
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPA
- Series
- Super X-Power M=S
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT XPA 1132 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for XPA 1132 and any equivalents.
The Optibelt XPA 1132 is a cogged narrow V-belt from the Super X-Power M=S series. It is built for compact, high-speed industrial drives where a standard wrapped belt would run too hot or slip. This page covers where the belt is used and how to confirm it fits your drive before you order.
Cogged narrow V-belts like this one are common on pumps, fans, compressors, mixers and machine tool drives. The XPA profile is a narrow cross-section, so it transmits the same load as a wider belt in less space and at higher speed. The 1132 mm length is the datum length you will find stamped on the belt back.
To confirm fit, read the marking on the old belt. You need the profile (XPA) and the length (1132 mm). Check the pulley grooves for wear, oil or glazing, and make sure the belt sits correctly in the groove without riding on the bottom. If the drive uses more than one belt, replace the full set at the same time so the load stays even.
Send us the part number XPA 1132, or a photo of the belt marking, and we will confirm the belt or suggest an equivalent. If you are unsure between profiles, include the pulley diameter and the center distance so we can cross-check.
Dimensions
- Section
- XPA
- Length
- 1132mm
Frequently asked questions
- How do I confirm this Optibelt XPA 1132 fits my drive?
- Check the marking on the back of the old belt. It should read XPA and 1132 mm. Also check that the belt sits correctly in the pulley groove and that the pulleys are not worn.
- Can I replace just one belt on a multi-belt drive?
- No. On a drive with two or more belts, replace the full set at the same time. Mixing a new belt with worn belts causes uneven load and early failure.
- What information do you need for a quote?
- Send the part number XPA 1132, or a photo of the belt marking. If you want us to check an equivalent, include the pulley diameter and center distance.