V-belt Optibelt X13 x 1150

OPTIBELT X13 x 1150 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for X13 x 1150 and any equivalents.

This Optibelt Super TX M=S belt is a cogged classical V-belt with an AX profile and a 1150 mm length. Cogged classical V-belts are commonly used on drives with small pulleys, short center distances or high-speed operation, where a raw-edge cogged construction helps the belt run cooler and grip the pulley. Confirm that your drive takes an AX profile and a 1150 mm belt before ordering.

The easiest way to confirm fit is to read the marking on the back of the old belt. Look for the profile and length, and compare them with AX and 1150 mm. If the old belt is worn, stretched or the marking is unreadable, measure the outside length and check the pulley groove width against the AX profile.

Cogged classical V-belts are found on fans, pumps, compressors, conveyors and other industrial drives that use classical section pulleys. Because the belt is cogged, it can bend around smaller pulleys than a wrapped belt of the same section, which is useful on compact drives. Inspect the pulleys for wear, alignment and debris at the same time.

If you are replacing a belt on a multi-belt drive, replace all belts in the set at once so they share the load evenly. Send the part number X13 x 1150, the profile AX and the length 1150 mm by WhatsApp or email, and the team will confirm the belt or suggest an equivalent.