V-belt Optibelt X13 2675 XEP

OPTIBELT X13 2675 XEP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for X13 2675 XEP and any equivalents.

The Optibelt X13 2675 XEP is a cogged classical V-belt in the AX profile with a length of 2675 mm, part of the Super XE-Power Pro M=S series. Before you fit it, take a few minutes to inspect the drive so the new belt starts on a clean, true running surface.

Check the sheaves first. Look for worn grooves, a polished or dished groove floor, and any burrs or rust that will scuff a belt. A groove worn wide lets a new belt sit too deep, so it slips and runs hot from the first shift. Run a straightedge across the sheave faces to confirm the two sheaves line up; misalignment is a common cause of short belt life.

Then check the rest of the drive. Spin the sheaves by hand and feel for rough or dry bearings, and confirm the shafts do not move or flex. Remove any debris or spilled material from the guard and the grooves. Set tension to the drive manufacturer's figure for this AX profile belt, then recheck it after the first hours of running.

The belt is marked X13 2675 XEP on the back, with the AX profile and the 2675 mm length. When you request a quote, send that full marking plus the quantity and the drive it goes on. If the old belt is worn or the marking is unreadable, send a photo of the belt and the sheaves.