V-belt Optibelt SPC 4750 BP2
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPC
- Series
- Blue Power 2
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT SPC 4750 BP2 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPC 4750 BP2 and any equivalents.
The Optibelt SPC 4750 BP2 is a narrow wedge V-belt from the Blue Power 2 series. The SPC profile and 4750 mm length are the two figures to match when selecting a replacement. Use them to confirm the belt fits your drive before requesting a quote.
Profile and length are the primary selection criteria for this belt. SPC designates a narrow wedge cross-section, and the datum length is 4750 mm. When reading the marking on the back of an old belt, compare both values directly against this listing. If the old belt shows SPC and 4750, this is the same size.
For a quote, send the part number SPC 4750 BP2 and the quantity you need. If the existing belt is worn or the marking is unreadable, measure the outside length and confirm the profile with a cross-section gauge, or send a photo of the belt and the drive sheave. The team can help confirm the right belt or suggest an equivalent.
Narrow wedge V-belts are often replaced as a set when a drive runs multiple belts. Check all belts on the drive for wear, glazing or tension loss, and note any sheave grooves that show steps or ridges. Replacing the full set keeps the load evenly distributed across the drive.
Dimensions
- Section
- SPC
- Length
- 4750mm
Frequently asked questions
- What do the SPC profile and 4750 mm length mean for my drive?
- SPC is the narrow wedge cross-section, and 4750 mm is the belt length. Both must match the drive's sheave grooves and center distance for the belt to seat and tension correctly.
- How do I confirm this is the right belt if the old marking is worn?
- Measure the outside length, check the cross-section against an SPC profile gauge, and compare the sheave groove width. Send those details or a photo with your quote request and the team can help confirm.
- Should I replace all belts on the drive at the same time?
- On a multi-belt drive, replacing the full set is standard practice. Mixed wear or mismatched lengths can cause uneven loading, vibration and premature failure of the new belt.