V-belt Optibelt SPC 4000 RP
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPC
- Series
- Red Power 3 S=C Plus
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT SPC 4000 RP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPC 4000 RP and any equivalents.
This Optibelt SPC 4000 RP belt is a narrow wedge V-belt from the Red Power 3 S=C Plus series. It has an SPC profile and a length of 4000 mm. Before you fit it, take a close look at the drive and the sheaves.
Worn sheave grooves will wear out a new belt quickly. Check the groove flanks for steps, ridges or polish marks, and check for cracks or chips at the rim. Measure groove wear with a sheave gauge where you can. If the grooves are worn past their limit, the new belt will sit too deep, slip and run hot.
Check alignment while the belt is off. Use a straightedge or laser across the sheave faces. Misalignment causes edge wear and heat. Also check the bearings for play, the bushing and key for damage, and the take-up for free travel. Any of these can shorten belt life even when the belt itself is correct.
The Optibelt SPC 4000 RP is a narrow wedge V-belt with an SPC profile and a 4000 mm length. Send the part number by WhatsApp or email to request a quote. If you are unsure of the profile or length, send a photo of the marking on the back of the old belt and the sheave dimensions.
Dimensions
- Section
- SPC
- Length
- 4000mm
Frequently asked questions
- What should I check on the drive before fitting this belt?
- Inspect the sheave grooves for wear, steps and cracks. Check sheave alignment with a straightedge or laser. Check bearings for play and the take-up for free travel. Correct any problem before you fit the new belt.
- How do I identify the belt I need?
- Read the marking on the back of the old belt. The SPC profile and the 4000 mm length identify this Optibelt SPC 4000 RP belt. If the marking is worn, measure the sheave grooves and the center distance.
- How do I request a quote?
- Send the part number Optibelt SPC 4000 RP by WhatsApp or email. Include the quantity and any details from the old belt marking. We reply promptly and can help confirm the right belt.