V-belt Optibelt SPB 1800 RP
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- Red Power 3 S=C Plus
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT SPB 1800 RP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPB 1800 RP and any equivalents.
The Optibelt SPB 1800 RP is a narrow wedge V-belt in the Red Power 3 S=C Plus series. It has an SPB profile, a 1800 mm length, a 16.3 mm top width, a 13 mm height and a 40 degree angle. If you are replacing a belt on an existing drive, the most reliable approach is to match the belt you are removing.
Start by reading the marking on the back of the old belt. The part number, profile and length should correspond to SPB, 1800 mm, 16.3 mm top width, 13 mm height and 40 degrees. If the old belt is worn, dirty or the marking is no longer clear, measure the length and the top width and compare them with these values. A belt that is close but not the same profile or length may not sit correctly in the pulley grooves.
When the drive uses more than one belt, replace the full set at the same time. Belts that have run together take a set and wear as a group, so mixing a new belt with used ones can leave the new belt carrying more than its share of the load. Confirm the pulley grooves are clean and free of damage before fitting, and check that the belt sits at the correct height in the groove.
For a quote, send the part number SPB 1800 RP, the brand Optibelt and the quantity you need. If the marking on your old belt is unclear, send a photo of the belt and the drive, along with the profile and length you measured. We carry Optibelt belts and can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- SPB
- Length
- 1800mm
Frequently asked questions
- How do I confirm this is the correct belt for my drive?
- Read the marking on the back of the belt you are replacing and compare it with SPB 1800 RP. The profile should be SPB, the length 1800 mm, the top width 16.3 mm, the height 13 mm and the angle 40 degrees. If the marking is not clear, measure the length and top width of the old belt and send those values with your request.
- Should I replace more than one belt at a time?
- Yes, if the drive uses multiple belts, replace the full set together. Used belts wear and take a set as a group, so a single new belt matched with used belts may not share the load evenly. Check the pulley grooves before fitting the new set.
- What should I send to request a quote?
- Send the part number SPB 1800 RP, the brand Optibelt and the quantity you need. If you are not certain of the part number, send a photo of the old belt and the drive, along with the profile and length you measured, and we can help confirm the right belt or suggest an equivalent.