V-belt Optibelt SPA 1207 RP
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPA
- Series
- Red Power 3 S=C Plus
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT SPA 1207 RP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPA 1207 RP and any equivalents.
When a narrow wedge V-belt needs replacement, the drive itself deserves a look before the new belt goes on. This Optibelt SPA 1207 RP belt is part of the Red Power 3 S=C Plus series, with an SPA profile and a 1207 mm length. Use the details here to confirm the fit and to plan the inspection.
Start with the sheaves. Worn grooves, rust, or a polished surface can shorten belt life and cause slippage even with a correct replacement. Check alignment between the pulleys, because misalignment is a common reason a narrow wedge V-belt runs hot or wears on one side. Confirm that the sheave profile matches the belt: this belt has an SPA profile, a 12.7 mm top width, a 10 mm height, and a 40 degree angle.
Inspect the rest of the drive as well. Look for worn bearings, a bent shaft, or debris that could contact the belt. If the drive uses multiple belts, replace them as a set so the load stays even. The Optibelt SPA 1207 RP is a narrow wedge V-belt with a 1207 mm length, and the Red Power 3 S=C Plus series is built for these industrial drives.
To request a quote, send the part number Optibelt SPA 1207 RP and the quantity you need. If you are unsure whether this is the right belt, include the belt marking and the drive details in your message. Our team can confirm the SPA profile and 1207 mm length, or suggest an equivalent.
Dimensions
- Section
- SPA
- Length
- 1207mm
Frequently asked questions
- What should I check on the drive before fitting this belt?
- Inspect the sheave grooves for wear, rust, or damage, and check pulley alignment. Also look at bearings and shafts for play or roughness. Correcting these issues before installation helps the new belt run properly.
- How do I identify the belt I am replacing?
- Look for the marking on the back of the old belt. The part number Optibelt SPA 1207 RP, the SPA profile, and the 1207 mm length are the key details to match. If the marking is worn, measure the top width and height to compare with the 12.7 mm and 10 mm dimensions.
- Can you help confirm the right belt for my drive?
- Yes. Send the part number, the old belt marking, and any drive details by WhatsApp or email. We will confirm the SPA profile and 1207 mm length, or suggest an equivalent.