V-belt Optibelt B 67 KB
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- KB
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT B 67 KB belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for B 67 KB and any equivalents.
The Optibelt B 67 KB is a banded V-belt in the KB series, with a length of 1778 mm. It is built for drives where multiple belts run as a set on the same sheaves. Before you fit a replacement, inspect the drive so the new belt starts on a sound system.
Check sheave grooves for wear, rust, or embedded debris. Worn grooves let the belt sit too deep, which leads to slip and heat. Confirm sheaves are aligned and that no groove has a step or ridge that will cut the belt edge. Spin the drive by hand and feel for rough or tight bearings.
Look at the old belt set as a group. If one belt in a banded set is worn or stretched, the whole set has seen the same service. Replace the full set so all belts share the load evenly. Clean the grooves before fitting the new Optibelt B 67 KB, and check that the take-up has enough travel to tension it correctly.
The belt is marked with its part number and length. When you request a quote, send the complete marking from the back of the belt, plus the drive make and model if you have it. That helps us confirm the B 67 KB, 1778 mm belt is the right fit for your application.
Dimensions
- Length
- 1778mm
Frequently asked questions
- What does the marking on the belt tell me?
- The back of the belt shows the brand, part number, and length. For this belt, look for Optibelt, B 67 KB, and 1778 mm. Send that full marking when you request a quote.
- Should I replace all belts on the drive at once?
- Yes. On a banded or multiple-belt drive, belts wear together. Replacing only one leaves the others at a different length and tension, so the set will not carry the load evenly.
- What should I check on the sheaves before fitting a new belt?
- Inspect each groove for wear, rust, or burrs, and confirm the sheaves are aligned. A worn or damaged groove can shorten the life of a new banded V-belt.