V-belt Optibelt AX 58

OPTIBELT AX 58 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AX 58 and any equivalents.

The Optibelt Super TX AX 58 is a cogged classical V-belt with an AX profile and a length of 1524 mm. Cogged classical belts of this type are commonly used on drives where a standard wrapped belt runs hot or slips, and the molded cogs help the belt flex around smaller pulleys. This page covers how to confirm the AX 58 fits your drive before you order.

The AX profile is the cogged version of the classical A cross-section, so it seats in the same pulley grooves as a standard A belt. The 1524 mm length is the datum length to compare against your existing belt. Measure the old belt only if you can read its marking clearly; otherwise match the profile and length stamped on the back of the belt to this listing. The same size is also listed under Stark AX 58 and Dayco AX 58, so those markings are an acceptable match if you find one of them on the machine.

Before ordering, check the drive for worn pulley grooves, misalignment and damaged sheaves, since a new belt will not correct those conditions. If the drive runs more than one belt, replace the full set at the same time so the load stays evenly shared. Confirm the belt sits correctly in the groove and that the take-up has enough adjustment to tension it properly.

To request a quote, send the part number AX 58 along with the quantity you need. If the marking on the old belt is worn or unreadable, send a photo of the belt and the pulley groove, plus the drive's pulley diameters and center distance, and we will help confirm the right belt or suggest an equivalent.