Timing belt Optibelt AT10 800

OPTIBELT AT10 800 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AT10 800 and any equivalents.

The Optibelt Alpha Power timing belt in AT10 800 is a synchronous belt with an AT10 profile, an 800 mm length and a 10 mm pitch. We carry it for maintenance and purchasing teams who need to match a belt already in service. The fastest way to confirm it is to read the marking on the back of the belt you are replacing.

Start with the belt itself rather than the machine documentation. A worn timing belt usually still carries its part number on the back, and on this belt that marking reads AT10 800. Compare the profile and the length on the old belt against the AT10 profile and 800 mm length listed here. If the drive has been modified or the belt is damaged past reading, check the pulley tooth profile and the center distance before ordering.

Profile and length are the two figures that have to agree. AT10 describes the tooth profile, and the 10 mm pitch is the spacing between tooth centers along the belt. The 800 mm length is the belt's own length, not the center distance of the drive. A belt that matches on profile but not on length, or the reverse, will not run correctly.

Once you have the marking, send it to us by WhatsApp or email with the quantity you need. We reply promptly and can confirm the AT10 800 or suggest an equivalent where one exists. If the drive runs more than one belt, note how many are on it and whether they were installed as a set, so the replacement goes in the same way.