V-belt Optibelt A 44
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- VB / HVAC Power
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
DODGE and OPTIBELT: matching part numbers →GATES and OPTIBELT: matching part numbers →OPTIBELT and STARK: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT A 44 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for A 44 and any equivalents.
When the marking on the back of an old belt is still readable, it gives you the profile and the length in one line. This Optibelt A 44 is a classical V-belt with an A profile and a length of 1168 mm. Use the marking to compare against the belt you are replacing.
The A profile is a classical V-belt cross-section. On this Optibelt belt the top width is 13 mm and the height is 8 mm, with a 40-degree angle. The length is 1168 mm. These dimensions come directly from the belt data, so you can check them against the old belt before ordering.
If the marking is worn or unreadable, measure the top width and the outside length of the old belt and send those values. The same size is also listed under Stark A 44. For a quote, send the part number A 44 or the dimensions you measured.
A classical V-belt can be replaced on its own, but on drives with multiple belts it is common practice to replace the full set so the belts share the load evenly. Inspect the sheaves for wear and check the tension after installation.
Dimensions
- Section
- A
- Length
- 1168mm
Frequently asked questions
- How do I confirm this is the right belt?
- Read the marking on the back of the old belt. If it shows A 44, this Optibelt belt matches that profile and length. You can also measure the top width and outside length and compare them to 13 mm and 1168 mm.
- What if the marking is no longer readable?
- Send the top width and the outside length of the old belt, or any remaining part number. The profile and length are the two values needed to identify a classical V-belt.
- Should I replace all belts on the drive at the same time?
- On a multi-belt drive, replacing the full set helps keep tension even across the belts. Check the sheaves for wear and set the tension according to the drive manufacturer's instructions.