Timing belt Optibelt 75 AT10 / 6000 AFX
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Alpha Flex
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 75 AT10 / 6000 AFX belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 75 AT10 / 6000 AFX and any equivalents.
The Optibelt 75 AT10 / 6000 AFX is an Alpha Flex timing belt with an AT10 profile, a 10 mm pitch and a 6000 mm length. Before you fit it, inspect the drive and the sheaves it runs on.
A new belt will not correct a worn drive. Check the sheaves for groove wear, damaged flanks and buildup in the grooves, and confirm the pulleys turn freely without play or binding. Look at the shafts, bearings and tensioning arrangement at the same time, since a misaligned or seized component will shorten the life of any belt you install.
Confirm the marking on the back of the old belt matches what you are replacing. This belt carries the Optibelt part number 75 AT10 / 6000 AFX, with an AT10 profile and a 6000 mm length on a 10 mm pitch. If the marking is worn off, measure the length and check the profile against the sheave before ordering.
Send the part number, the profile and the length by WhatsApp or email and we will confirm the belt. If you are replacing more than one belt on the same drive, include the quantity and the position of each so we can quote the full set.
Dimensions
- Profile
- AT10
- Pitch
- 10mm
- Length
- 6000mm
Frequently asked questions
- What do I need to send to get a quote for this belt?
- Send the part number 75 AT10 / 6000 AFX, or the profile AT10 and the 6000 mm length, by WhatsApp or email. If you are replacing several belts on the same drive, include the quantity.
- What should I check on the drive before fitting this belt?
- Inspect the sheaves for groove wear and damage, confirm the pulleys turn freely, and check shaft alignment, bearings and the tensioning arrangement. Correct any fault before the new belt goes on.
- How do I confirm this is the right belt if the old one is worn?
- Read the marking on the back of the old belt and compare it with 75 AT10 / 6000 AFX. If the marking is gone, measure the length and check the profile against the sheave.