V-belt Optibelt 5VX 800 XEP
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- 5VX
- Series
- Super XE-Power Pro M=S
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 5VX 800 XEP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5VX 800 XEP and any equivalents.
The Optibelt 5VX 800 XEP is a cogged narrow V-belt in the 5VX profile with a length of 2032 mm. It belongs to the Super XE-Power Pro M=S series and is built for drives that call for a 5VX cross-section rather than a wrapped classical belt. Read the profile and length off the old belt before you order.
The 5VX profile is the narrow wedge cross-section, so this belt sits in a 5VX sheave groove and not in a 5L or B-section pulley. The 2032 mm length is the datum you match against the drive, so confirm both the profile and the length rather than the part number alone. A belt that is close in length but wrong in profile will not seat correctly in the groove.
The cogged construction is the other thing to note. The molded teeth on the underside let the belt flex over smaller pulleys, which suits compact drives where a wrapped belt would run hot. The Super XE-Power Pro M=S series is the Optibelt line this belt comes from, and the 5VX 800 XEP marking on the back is what identifies it.
If the drive runs more than one belt, replace the full set at the same time so the load stays even across the grooves. Inspect the sheaves for wear, glazing or a worn groove profile before the new belts go on, since a bad groove will shorten the life of any belt you fit.
Dimensions
- Section
- 5VX
- Length
- 2032mm
Frequently asked questions
- How do I confirm this is the right belt for my drive?
- Check the profile and length on the old belt. This one is a 5VX profile at 2032 mm, so both figures need to match the drive. Send us the marking from the back of the belt and we will confirm the match.
- What does the cogged construction change?
- The molded cogs on the underside allow the belt to bend over smaller pulley diameters than a wrapped belt of the same cross-section. That makes it a fit for compact, higher-flex drives.
- What should I send for a quote?
- Send the part number 5VX 800 XEP, the quantity you need, and the marking from the old belt if you have it. A photo of the drive or the sheave grooves also helps us confirm the profile.