Timing belt Optibelt 5MHP 630

OPTIBELT 5MHP 630 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5MHP 630 and any equivalents.

The Optibelt 5MHP 630 is a timing belt in the Omega HP series with an HTD 5M profile and a 630 mm length. The 5 mm pitch identifies the tooth spacing, so you can match the belt to the pulley groove and center distance before ordering. Use the part number 5MHP 630 when you request a quote.

The profile and length are the two numbers that decide fit. HTD 5M is a synchronous profile with rounded teeth and a 5 mm pitch; the 630 mm length is the datum you compare against the old belt or the drive drawing. If the marking on the back of the belt reads 5MHP 630, this is the same profile and length.

For a maintenance or purchasing professional, the fastest check is to read the belt back: profile, pitch and length. The Optibelt 5MHP 630 covers HTD 5M drives that call for a 630 mm belt. Send the part number, the quantity, and a photo of the back marking if it is worn, and the team can confirm the belt or suggest an equivalent.

When you replace a timing belt, inspect the pulleys for worn teeth, debris or misalignment, and check that the flanges are not rubbing. On drives that use more than one belt, replace the set together so the load stays even. The 5MHP 630 is the reference for the belt you are replacing.