Timing belt Optibelt 50 / 8M 9800 AFX

OPTIBELT 50 / 8M 9800 AFX belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 50 / 8M 9800 AFX and any equivalents.

The marking on the back of a worn timing belt is often the only reliable record of what the drive was built around. This page covers the Optibelt 50 / 8M 9800 AFX from the Alpha Flex series, a timing belt in the HTD 8M profile. Read the numbers off the old belt and match them here before you request a quote.

The belt is identified by its profile and length. This one is an HTD 8M profile with a length of 9800 mm and a pitch of 8 mm. Those three values are what the drive was set up for, so they are what you compare against when the old belt is in hand. A belt that has run for years may have lost legible print, but the profile and length still have to line up.

If the back of the belt is readable, note the full marking including the part number, the profile and the length. If it is not, measure what you can and photograph the belt, the sprockets and the drive arrangement. Send the part number 50 / 8M 9800 AFX, or the details you do have, by WhatsApp or email and the team will confirm the belt against your data.

For drives that run more than one belt, replace the set together so the load stays even across the sprockets. Check sprocket wear, alignment and tension while the drive is open, since a new belt on worn sprockets will not hold its service life. The Alpha Flex series is what this belt is built in, and it is supplied in the HTD 8M profile at 9800 mm.