Timing belt Optibelt 32 AT10K13 / 9400 AFX
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Alpha Flex
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 32 AT10K13 / 9400 AFX belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 32 AT10K13 / 9400 AFX and any equivalents.
A timing belt is only as good as the drive it runs on, so it pays to inspect the pulleys and the rest of the drive before the new belt goes on. This page covers the Optibelt 32 AT10K13 / 9400 AFX from the Alpha Flex series, an AT10 profile synchronous belt with a 9400 mm length and a 10 mm pitch.
Before fitting, check the pulleys for worn teeth, damage or buildup in the grooves, and confirm they are aligned and running true. Look over the shafts, bearings and tensioner as well, since a worn component will shorten the life of any new belt. Correct tension and alignment matter just as much as the belt itself.
The Optibelt 32 AT10K13 / 9400 AFX is a timing belt in the Alpha Flex series. It has an AT10 profile, a 9400 mm length and a 10 mm pitch. Use the profile and length to match it to the drive, and read the marking on the back of the old belt to confirm you are ordering the same item.
If you are replacing more than one belt on the same drive, fit them as a set so the load stays even. Send us the part number, the profile and the length from the belt you are replacing, and we will help confirm the right belt or suggest an equivalent.
Dimensions
- Profile
- AT10
- Pitch
- 10mm
- Length
- 9400mm
Frequently asked questions
- What should I check on the drive before installing this belt?
- Inspect the pulleys for worn or damaged teeth and buildup in the grooves, and confirm they are aligned and running true. Check the shafts, bearings and tensioner for wear, then set tension correctly after fitting.
- How do I confirm this is the right belt for my drive?
- Match the AT10 profile and the 9400 mm length to your drive, and read the marking on the back of the belt you are replacing. If you send us the part number and the marking, we can help confirm the match.
- Can you help if I need more than one belt for the same drive?
- Yes. Send the part number, profile and length for each belt, and we will help confirm the right belts or suggest an equivalent so the drive runs with a matched set.