V-belt Optibelt 3-D 8000

OPTIBELT 3-D 8000 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 3-D 8000 and any equivalents.

This Optibelt 3-D 8000 is a banded V-belt from the KB VB series with a length of 8000 mm. The part number identifies a specific profile and length, so the marking on the old belt is the fastest way to confirm it. We carry this belt and quote it by part number.

For a maintenance or purchasing professional, the two numbers that matter on this page are the series and the length. KB VB gives you the profile family, and 8000 mm gives you the outside length. If your drive was built around that combination, this is the belt to specify. If the old belt is worn or the marking is gone, measure the length and note the profile before you request a quote.

Banded V-belts are used where a single belt would not carry the load or where matched sets are required. The band ties the ribs together, so the belt runs as one unit across a multi-groove drive. When you replace it, check the sheaves for wear and misalignment, and confirm that every groove is clean. On a drive that uses more than one belt, replace the full set so the load stays even.

To get a quote, send the part number 3-D 8000, the quantity, and the drive it goes on. If you have the old belt, a photo of the back marking helps us confirm the profile and length. We reply by WhatsApp or email and can help you match the belt or suggest an equivalent.