V-belt Optibelt 17 X 7000 CP
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Conveyor Power
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 17 X 7000 CP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 17 X 7000 CP and any equivalents.
The Optibelt 17 X 7000 CP is a classical V-belt in the Conveyor Power series, built for drives that use profile B sections. This page gives you the dimensions and the practical steps to match it to the belt you are replacing.
Start by reading the marking on the back of the old belt. If it shows 17 X 7000 CP, you have a direct match. The profile is B, the length is 7000 mm, the top width is 17 mm, the height is 11 mm, and the angle is 40°. Compare those numbers with the belt on the drive before you request a quote.
If the marking is worn or missing, measure the old belt. Check the top width and height against the 17 mm and 11 mm figures, and confirm the length against 7000 mm. A profile B belt with a different length will not fit the same drive. When you contact us, send the part number 17 X 7000 CP and the dimensions you measured.
For drives that run more than one belt, replace the full set at the same time. A new belt mixed with worn belts can sit at a different height in the groove and change how the load is shared. Confirm the sheave grooves are clean and free of wear before installing the new set.
Dimensions
- Section
- B
- Length
- 7000mm
Frequently asked questions
- How do I confirm the 17 X 7000 CP is the right belt for my drive?
- Read the marking on the back of the old belt. If it reads 17 X 7000 CP, it is the same belt. If the marking is not clear, measure the top width, height and length and compare them with 17 mm, 11 mm and 7000 mm.
- What should I send to request a quote for this belt?
- Send the part number 17 X 7000 CP and, if you have it, the marking from the old belt. If the marking is gone, include the profile, top width, height and length you measured.
- Should I replace all belts on the drive at once?
- Yes. On a multi-belt drive, replace the full set together so the belts share the load evenly. Check the sheave grooves for wear before you install the new set.