V-belt Optibelt 17 x 1150 Li
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- VB S=C Plus
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 17 x 1150 Li belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 17 x 1150 Li and any equivalents.
This Optibelt VB S=C Plus belt is a classical V-belt in profile B, with a top width of 17 mm, a height of 11 mm and a 40 degree angle. The 1150 mm length is the datum that decides whether it fits your drive, so it is worth reading both figures off the old belt before you order.
Profile and length are the two things to confirm first. Profile B sets the cross-section that has to sit correctly in the pulley groove: 17 mm across the top, 11 mm high, 40 degree angle. The 1150 mm length is the outside length marked on the belt as 17 x 1150 Li.
The cleanest way to match a replacement is to read the marking on the back of the belt you are removing. If the number is worn away, measure the outside length and check the top width and height against the profile above, then send those figures with your equipment details.
On drives that run more than one belt, replace the full set at the same time so the belts share the load evenly. Inspect the pulleys for wear, alignment and groove condition while the belts are off, since a worn groove will shorten the life of any new belt.
Dimensions
- Section
- B
- Length
- 1150mm
Frequently asked questions
- What does 17 x 1150 Li mean on this belt?
- It is the marking on the belt: profile B with a 17 mm top width and an 1150 mm outside length. The height is 11 mm and the angle is 40 degrees.
- How do I confirm this is the right belt for my drive?
- Read the marking on the back of the belt you are replacing and compare the profile and length. If it is unreadable, measure the outside length and the top width and send those with your equipment details.
- What should I send to get a quote?
- Send the part number 17 x 1150 Li, or the Optibelt VB S=C Plus marking, by WhatsApp or email. A photo of the old belt and the pulley groove helps us confirm the profile.