Timing belt Optibelt 150 AT10 / 9200 AFX
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Alpha Flex
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 150 AT10 / 9200 AFX belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 150 AT10 / 9200 AFX and any equivalents.
The Optibelt 150 AT10 / 9200 AFX is a timing belt from the Alpha Flex series with an AT10 profile, a 9200 mm length and a 10 mm pitch. Before you fit it, inspect the drive and sheaves so the new belt runs true from the start.
Check the sheaves for worn teeth, debris in the grooves and any runout or misalignment that would shorten belt life. Confirm the shaft bearings turn freely, the tensioner moves through its full range, and the drive guards are clear of the belt path. Correct any problems before installation, because a new belt will not fix a worn drive.
Match the belt to the drive by its marking: AT10 profile, 9200 mm length, 10 mm pitch. If the old belt is unreadable, measure the length and count the teeth to confirm the AT10 profile before ordering. Send the part number 150 AT10 / 9200 AFX by WhatsApp or email with your quantity, and our team will confirm the belt or suggest an equivalent.
After fitting, recheck alignment and tension, then run the drive without load and listen for unusual noise. Recheck tension after the first hours of operation. For multiple-belt drives, replace all belts at the same time so the load stays even across the set.
Dimensions
- Profile
- AT10
- Pitch
- 10mm
- Length
- 9200mm
Frequently asked questions
- What should I check on the drive before fitting this belt?
- Inspect sheaves for worn teeth, debris and misalignment, confirm bearings and the tensioner move freely, and clear the belt path. Fix any issue first; a new belt will not correct a worn drive.
- How do I confirm the belt if the old marking is gone?
- Measure the belt length and count the teeth to confirm the AT10 profile and 9200 mm length. Send the part number 150 AT10 / 9200 AFX with your quantity and our team will confirm the belt or suggest an equivalent.
- Should I replace all belts on a multi-belt drive at once?
- Yes. Replace all belts in the set at the same time so the load stays even across the drive and the new belts wear together.