Timing belt Optibelt 1330 D14M 40
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Omega
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 1330 D14M 40 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 1330 D14M 40 and any equivalents.
The Optibelt Omega 1330 D14M 40 is a double-sided timing belt with a length of 1330 mm. It is used where a drive needs synchronous power transmission from both faces of the belt. To match it to the belt being replaced, compare the marking and the length first.
Start by reading the back of the old belt. Confirm the profile and the length match this belt: 1330 mm. The part number 1330 D14M 40 identifies the same profile and length, so it is the reference to quote. If the old belt is worn or the marking is unreadable, measure the length and note the profile before ordering.
A double-sided timing belt has teeth on both sides, so it can drive pulleys from either face. That makes it different from a single-sided timing belt, and it cannot be replaced by one. Check the pulley grooves and the belt width to be sure the replacement fits the same way. If the drive uses two belts, replace them as a set so the load stays even.
We carry the Optibelt Omega 1330 D14M 40. Send the part number by WhatsApp or email to request a quote. If you are unsure about the profile or length, include a photo of the belt marking and the pulley arrangement. The team can confirm the right belt or suggest an equivalent.
Dimensions
- Length
- 1330mm
Frequently asked questions
- How do I confirm this is the correct belt for my drive?
- Read the marking on the back of the belt being replaced. It should show the same profile and length as the 1330 D14M 40. If the marking is not clear, measure the length and check the pulley grooves before requesting a quote.
- Can I use a single-sided timing belt instead of this double-sided belt?
- No. A double-sided timing belt has teeth on both sides and is used where the drive needs synchronous transmission from both faces. A single-sided belt will not fit or work in that arrangement.
- What information should I send with my quote request?
- Send the part number 1330 D14M 40. If you are replacing an existing belt, include the marking from the old belt and, if possible, a photo of the drive. That helps confirm the profile and length.