Timing belt Optibelt 1330 14M 170 HILO
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Omega High Load
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 1330 14M 170 HILO belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 1330 14M 170 HILO and any equivalents.
The Optibelt 1330 14M 170 HILO is an HTD 14M timing belt with a 1330 mm length and a 14 mm pitch. It is used in synchronous drives where the belt teeth mesh with matching pulleys to keep the driven shaft in step with the driver. This belt is suited to industrial machinery and power transmission equipment that runs an HTD 14M drive.
To confirm fit, check that the drive uses an HTD 14M pulley profile and that the belt's 1330 mm length matches the original. The 14 mm pitch identifies the tooth spacing, so the pulleys must be cut for the same pitch. If the old belt is worn or its marking is unreadable, measure the outside length and count the teeth to verify the replacement.
This belt is commonly found on drives where slip is not acceptable, such as those on industrial equipment and process machinery. Inspect the pulleys for worn teeth, alignment, and correct tension before installing a new belt. Replace the belt if you see cracked teeth, exposed cord, or glazing on the tooth faces.
We carry the Optibelt 1330 14M 170 HILO and can help you confirm it is the right belt for your drive. Send the part number, the belt marking, or a photo of the old belt by WhatsApp or email for a quote.
Dimensions
- Profile
- HTD 14M
- Pitch
- 14mm
- Length
- 1330mm
Frequently asked questions
- How do I confirm this belt fits my drive?
- Check that your pulleys are HTD 14M profile and that the belt length matches 1330 mm. The 14 mm pitch must match the pulley tooth spacing. If you are unsure, send us the old belt marking or a photo.
- What should I send for a quote?
- Send the part number 1330 14M 170 HILO, or the marking on the back of the old belt, by WhatsApp or email. A photo of the belt and pulleys also helps us confirm the correct replacement.
- When should I replace a timing belt?
- Replace it if you find cracked or missing teeth, exposed cords, glazing, or if the belt has been running with incorrect tension or misaligned pulleys. Inspect the pulleys at the same time.