V-belt Optibelt 13 x 2464 Li
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- VB S=C Plus
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 13 x 2464 Li belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 13 x 2464 Li and any equivalents.
This Optibelt VB S=C Plus belt is a classical V-belt with an A profile and a 2464 mm length. It measures 13 mm across the top and 8 mm in height, with a 40 degree angle. It suits industrial drives that take a classical A-section belt rather than a narrow wedge or cogged design.
Classical V-belts in the A profile are common on older and general-purpose drives where the pulley groove was cut for this section. If you are replacing a belt on that kind of drive, confirm the section against the pulley groove first, then confirm the length. The marking on the back of the old belt is the fastest starting point: read the profile and the length from it and match them to this belt.
The 13 mm top width and 8 mm height identify the A section, and the 40 degree angle is the standard flank angle for this profile. The 2464 mm length is the datum length stated for this belt. Measure the old belt only if the marking is no longer readable, and check the drive for worn grooves, misalignment or a failed tensioner before fitting a new belt.
Where a drive runs more than one belt, replace the full set at the same time so the belts share the load evenly. Send the part number, the profile and the length from your old belt, and the quantity you need. We can confirm the correct belt or suggest an equivalent.
Dimensions
- Section
- A
- Length
- 2464mm
Frequently asked questions
- How do I confirm this belt fits my drive?
- Check the pulley groove section against the A profile, then confirm the length. The clearest reference is the marking on the back of the belt you are replacing. If it is unreadable, measure the old belt and check the pulley grooves for wear.
- What do I need to send for a quote?
- Send the part number 13 x 2464 Li, or the profile and length from your old belt, along with the quantity. If you are unsure of the section, include the top width and height you measure.
- Should I replace more than one belt at a time?
- On a multi-belt drive, replace the whole set together. Belts of different wear or length do not share load evenly, and a single new belt alongside older ones can run at the wrong tension.