NTN UKP210D1 pillow block bearing

NTN UKP210D1 belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for UKP210D1 and any equivalents.

The NTN UKP2 is a ready-to-mount foot unit that pairs a cast iron housing with a UK series insert bearing. It supports shafts in belt, chain, and coupling drives where straightforward alignment and bolting are needed. MR Industrial Accessories LLC supplies this line to industrial customers across the United States and Latin America.

Reading the UKP2 code helps you order correctly. UK stands for the insert bearing with taper sleeve and set screws. P is the split pillow block housing. The number after P gives the insert and housing size. The D1 suffix marks the sealing and fastening variant NTN uses in this series. All part numbers follow this pattern; only the shaft diameter changes.

You will find these units on belt conveyors, bucket elevators, mixers, screens, packaging lines, screw conveyors, water wheels, and mills. They suit food, cement, mining, and agro-industrial plants. The cast iron housing takes radial loads and bolts to a flat base with two fasteners. Foot mounting simplifies maintenance because you do not need to remove the entire shaft.

To select, note the shaft diameter, the radial load, and whether axial load is present. The UK insert with taper sleeve locks to the shaft using a lock nut and lock washer, which speeds mounting and dismounting. Check base alignment and parallelism between housings. Lubrication is applied at the factory; in service, add grease through the fitting based on the duty cycle. The D1 seal guards against dust and splashes, but in very dirty areas consider additional seals.

NTN UKP housings interchange with other brands that share the same mounting standard and shaft sizes. If you have a part number from another supplier or an unmarked part, MR can identify the compatible alternative. Interchangeability depends on shaft diameter and insert type, not the commercial part number. A photo or the number cast on the housing helps us confirm.

For a UKP unit with insert bearing, message us on WhatsApp or email with the part number or shaft size. We work with the NTN line and can suggest the right variant for your equipment.