NSK UKFC209D1;HS2309X flange bearing 4 holes
- Brand
- NSK
- Category
- Bearing housings
- Subcategory
- Y-bearing unit
- Series
- UKFC
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
NSK UKFC209D1;HS2309X belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for UKFC209D1;HS2309X and any equivalents.
A UKFC unit pairs an NSK insert bearing with a cast iron flange housing. Four bolts hold it to a flat surface, with the mounting face at the front. Shafts are supported in this way where the equipment needs a compact arrangement, straightforward alignment and some protection from dirt and moisture.
Reading the code helps when ordering. UKFC points to the flange housing family that takes an insert bearing. The digits after it set the size. A D1 suffix marks a particular sealing and insert design. Codes such as HS2308X refer to the insert itself, which carries its own series and diameter designation.
Typical installations include conveyors, belt systems, elevators, mixers, fans and farm equipment. Food processing plants, cement operations, cold storage rooms and metalworking shops use them because mounting on a wall or structural panel keeps service simple. The four-bolt flange holds the unit firmly, and the insert can be swapped out without pulling the housing off the structure.
Selection starts with shaft diameter and load type: radial, axial or a combination. The insert seal has to suit the surroundings, whether that means dust, damp air or regular washdowns. When fitting the unit, line up the flange holes and tighten the bolts in a cross pattern. Follow the duty cycle for lubrication and verify axial clearance. Good alignment keeps vibration down and helps the bearing last.
Units with the same nomenclature and flange dimensions interchange across brands. If a customer sends a code from another maker, the match can be worked out from shaft size, hole spacing and outside diameter. MR Industrial Accessories LLC supplies the NSK line and can advise on the substitution while keeping the original tolerances and seal style in mind.
For a quote on a UKFC housing with NSK insert bearing, send the full code through WhatsApp or email, for example UKFC208D1 or HS2308X, or provide the shaft and flange dimensions. The team responds promptly and can suggest equivalents or help with the selection.
Dimensions
- Bore
- 1-5/8 in
Frequently asked questions
- What does UKFC indicate on a housed bearing unit?
- UKFC refers to a four-bolt flange unit that holds an insert bearing. The number that follows gives the shaft size: UKFC208 fits a 40 mm shaft, UKFC209 a 45 mm shaft. D1 shows a specific sealing and insert variant.
- What information is needed to pick the correct UKFC housing?
- Shaft diameter, load direction and the conditions where the unit will run. Consider whether the seal must handle dust or moisture. The flange has to match the mounting surface. With those details, the exact code can be quoted.
- Can an NSK UKFC replace a housing from a different brand?
- It can when the flange dimensions and shaft diameter line up. Interchange relies on standard dimensions. Send the original code or the measurements and the corresponding NSK equivalent can be identified.