NSK UCS210-200LD1NW3 insert bearing

NSK UCS210-200LD1NW3 belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for UCS210-200LD1NW3 and any equivalents.

The NSK UCS series is an insert bearing with an extended inner ring and set screws, made to sit inside split plummer block or pillow block housings. It suits equipment that needs a sealed unit which mounts and comes apart easily and stands up to dust and moisture. MR Industrial Accessories supplies this series and quotes it from the code or shaft size you send.

Read the code in sections. UCS marks the insert family with set screws; the digits after it give the bore size; LD1 and NW3 are sealing and configuration variants. So UCS210-113LD1NW3, UCS210-114LD1NW3 and UCS210-115LD1NW3 use the same body with a different bore diameter, while UCS210LD1NW3 is the base reference. Send the complete code and the exact size is quoted back to you.

Typical installations are conveyors, belts, elevators, mixers, fans and process lines, including food, chemical, cement and agricultural plants where dust and moisture are present. A frequent case is a reconditioned machine: the insert is swapped out and the housing stays in place. If the equipment runs with heavy vibration or load, say so when you ask for the quote.

Selection comes down to three things: shaft diameter, whether the load is radial, axial or combined, and the conditions on site. The LD1 seal is the barrier against dust and splashes. Before mounting, the shaft and housing should be clean and free of burrs; the set screws go tight against the shaft with the right wrench, and the ring is never struck with a hammer. Good lubrication and careful alignment are what keep the insert running. Send a photo or the code if you want help deciding.

Crossing an insert from one brand to another rarely works letter for letter. What has to line up is the shaft diameter, the inner ring width and the fixing method. Bring the original part or the manufacturer's code and the equivalent can be identified and quoted. The shaft size alone, or a photo of the part, is usually enough for a precise answer.

The NSK UCS series sits alongside the other bearing and housing lines MR Industrial Accessories carries. Send the code or the shaft size and the quote follows promptly, with guidance on mounting and lubrication if you need it.