Industrial pulley 340 mm, 6 grooves, section C

EMMAR POLEA 340 6C belongs to pulleys, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for POLEA 340 6C and any equivalents.

When you need to transmit power through multiple C-section V-belts, the EMMAR 340 6C pulley is built for the job. With a 340 mm diameter and six grooves, it suits high-demand drives where several belts share the load. Because MR manufactures this pulley in-house, the bore and keyway can be adapted to your equipment's shaft. Send the part number POLEA 340 6C by WhatsApp or email for a prompt quote.

This pulley carries the designation POLEA 340 6C. The 340 mm diameter sets the transmission ratio when paired with a driven pulley, while the six grooves allow up to six C-section belts to run in parallel. Section C is a wide-profile V-belt standard, so the grooves are machined to match that profile. The part is made from cast iron or machined steel, with ground grooves for proper belt seating. As an in-house manufactured item, it can be supplied with the bore and keyway your shaft requires.

You will find this size and groove count on equipment that demands high torque: mills, mixers, screw compressors, large centrifugal pumps, industrial fans and heavy machinery drives. Running multiple belts distributes the load across them, which helps reduce the strain on any single belt. The pulley can serve as either the drive or driven side, depending on the ratio you need. In all cases, confirm that the belt section matches the groove profile before installation.

Selecting the right pulley starts with three numbers: pitch diameter, number of grooves and belt section. For this model, that means 340 mm, 6 and section C. Check that your belts are actually C-section, since other profiles will not seat correctly. The bore and keyway must match the shaft; if they do not, the bore can be machined to the required size. Also verify alignment between the two pulleys to prevent uneven belt and bearing wear.

If you are replacing a pulley from another source, the simplest approach is to send us the part number POLEA 340 6C or the original data: diameter, number of grooves, section and shaft diameter. With that information we can quote an in-house manufactured pulley that matches the performance or suggest the size that fits your equipment best. Where space permits, we can also manufacture to your specific dimensions.

To request a quote or ask about a variant, send the part number POLEA 340 6C by WhatsApp or email. If you are unsure about an equivalent, include a photo or the details of the original part and we will help you choose.