Industrial pulley 150 mm, 1 groove, section C

EMMAR POLEA 150 1C belongs to pulleys, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for POLEA 150 1C and any equivalents.

The EMMAR POLEA 150 1C is a single-groove V-belt pulley made in-house, sized at 150 mm in diameter for a section C belt. It transfers motion between shafts on equipment that calls for a straightforward, dependable drive ratio. The groove is machined and the body is metal, which lets the belt sit properly and wear evenly. This is a component intended for machines running at moderate loads and at speeds that fall within the normal range for section C.

Three variables define the part: diameter, groove count and belt section, and the code POLEA 150 1C captures all three. Section C is a mid-sized V-belt profile, and with only one groove the pulley suits single-strand drives. Manufacturing takes place at MR with dimensional checks on the outer diameter, the groove width and the center bore, so the fit on the shaft comes out right.

Fans, centrifugal pumps, screw compressors, light conveyor belts and machine tools are common homes for a pulley of this type. It also fits belt-driven equipment where an existing pulley has to be replaced or a drive is being built from scratch. Because it is a single-groove section C unit, it tends to appear in installations where transmitted power is moderate and maintenance stays simple.

Selection comes down to the pitch diameter, the width of the section C belt and the shaft diameter it will sit on. Confirm the keyway lines up with the shaft and that the fastening method, whether a set screw or a taper bushing, matches the load. Pulley alignment matters for keeping belt wear and vibration down. On high-speed duty, check static balancing before the pulley goes into service.

Need a different size, a different groove count or another section? We can make it or locate an equivalent. Send the part number POLEA 150 1C, or the details of the pulley you are replacing: diameter, grooves, section and shaft diameter. From there we quote an in-house manufactured EMMAR pulley or an alternative that does the same job. Belt selection advice for your drive is available as well.

MR Industrial Accessories LLC manufactures this pulley along with other power transmission parts. To request a quote for the POLEA 150 1C, reach out on WhatsApp or by email and the team will reply with the technical information you need. Send the part number directly and the quote follows promptly.