Industrial pulley 60 mm, 2 grooves, section A

EMMAR POLEA 60 2A belongs to pulleys, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for POLEA 60 2A and any equivalents.

The EMMAR 60 2A pulley is a power transmission component manufactured in-house. It has a 60 mm diameter and two grooves for section A V-belts. This pulley transmits motion between shafts in equipment that requires a simple, reliable ratio. The two-groove design allows one or two belts to run in parallel, which can provide redundancy and distribute the load across both grooves. It is suited for machines that operate continuously.

The designation POLEA 60 2A identifies the three key variables: a 60 mm diameter, two grooves, and section A. Section A is a classic V-belt profile. The pulley is made by MR, and the part number is used for ordering and replacement. Before quoting, we can verify the root diameter, overall width, and bore type against the manufacturing data sheet.

Common applications for a 2-groove section A pulley include fans, centrifugal pumps, small compressors, conveyors, and machine tools. In these systems, the pulley mounts on a motor or driven shaft and transfers motion through belts. With two grooves, you can run a single belt or two in parallel, depending on the power to be transmitted and the level of safety desired. This setup is often found where a broken belt should not stop the process.

When selecting or installing this pulley, consider the pitch diameter, number of grooves, and belt section. Section A works within a limited range of pulley diameters; if the diameter is too small, the belt bends more and wears faster. Also check pulley alignment, belt tension, and groove condition. Burrs or wear can cause noise and shorten service life. The keyway and shaft fastening must be clean and tightened according to the equipment design.

To request an equivalent pulley, send the part number POLEA 60 2A or the original pulley's part number via WhatsApp. With that information, we can propose an in-house manufactured pulley that fits or adapt it in number of grooves or diameter. We can also advise on a compatible section A belt and on any bushings or sleeves needed for installation.

MR manufactures this pulley and other power transmission parts. If the pulley you need does not exactly match POLEA 60 2A, it is still worth asking. Often a variant in the same series can solve the problem. Send the part number, equipment brand, or a photo of the old pulley, and we will reply with the best alternative. Quotes are handled via WhatsApp or email.