Industrial pulley 260 mm, 2 grooves, section A
- Brand
- EMMAR
- Category
- Power transmission
- Subcategory
- Pulleys
- Section
- A
- Series
- Sección A
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
EMMAR POLEA 260 2A belongs to pulleys, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for POLEA 260 2A and any equivalents.
The EMMAR 260 2A is a V-belt drive pulley with a 260 mm diameter, two grooves, and section A profile. It transfers torque from a motor to a driven shaft, adjusting speed based on the paired diameters. As an in-house manufactured item, it is machined to the bore and keyway dimensions required for your specific equipment. It is commonly found on fans, compressors, pumps, conveyors, and other factory machinery.
The part number POLEA 260 2A encodes the key specifications: 260 mm outside diameter, 2 grooves, and section A. Section A grooves accept V-belts of that profile, and with two grooves the drive can run two belts in parallel. The pulley is a machined cast iron component, with the bore and keyway defined at the time of order.
Typical uses include equipment that needs to transmit torque from an electric motor or gearbox: centrifugal fans, screw compressors, centrifugal pumps, conveyor belts, and general factory machinery. It also serves as a replacement for worn pulleys or to change the drive ratio when operating speed is modified. In all cases, inspect belt condition and check pulley alignment before installation.
When selecting, consider the pitch diameter, number of grooves, and the belt section already in use. Verify the shaft bore, keyway length, and fastening method: set screw, key, or taper bushing. If the pulley will see axial load, confirm the hub width is sufficient. Proper alignment between pulleys and correct belt tension are critical for service life.
If you need a different diameter, send the part number of the pulley being replaced, the shaft diameter, and the belt section. With that information, we can source or manufacture an equivalent part. We can also quote the pulley with the bore and keyway already machined to match your sample or drawing. Contact us via WhatsApp or email with the part number POLEA 260 2A to request a quote.
Dimensions
- Size
- 260mm
- Grooves
- 2
- Section
- A
Frequently asked questions
- What does 260 2A indicate in the designation?
- It represents the three main specifications: 260 mm diameter, 2 grooves, and section A. This is how the pulley is identified in our catalog and in quotations.
- Can I order it with a different shaft bore?
- Yes. Because it is in-house manufactured, the bore, keyway, and fastening type are defined according to the shaft where it will be mounted. Provide the shaft dimensions and a sample or drawing.
- How do I request an equivalent pulley?
- Send the part number of the original pulley, the shaft diameter, and the belt section via WhatsApp or email. We will source an equivalent or manufacture it to your required size.