V-belt Movendis PP-XPC2650-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPC
- Series
- PowerPlus EPDM Cogged Raw Edge Narrow
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-XPC2650-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-XPC2650-EPDM-AS and any equivalents.
The Movendis PP-XPC2650-EPDM-AS is a PowerPlus EPDM cogged raw edge narrow V-belt in the XPC profile with a length of 2650 mm. Before you fit it, inspect the drive and sheaves so the new belt starts on a sound system.
Check sheave grooves for wear, rust, or embedded debris, and confirm the sheaves are aligned and free of oil or grease. A worn or damaged groove can shorten belt life and cause vibration even when the belt itself is correct. Verify that the drive takes an XPC profile belt and that the 2650 mm length matches the old belt or the drive specification.
The cogged raw edge construction is suited to compact drives where standard wrapped belts may not flex as needed. EPDM compounds are used in this series for resistance to heat and cracking. If you are replacing more than one belt on a multi-belt drive, fit the full set at the same time so the load is shared evenly.
To request a quote, send the part number PP-XPC2650-EPDM-AS by WhatsApp or email. If you are unsure whether this is the right belt, include the old belt marking, the profile, and the length in millimeters. Our team can confirm the belt or suggest an equivalent.
Dimensions
- Section
- XPC
- Length
- 2650mm
Frequently asked questions
- What does the marking on the old belt tell me?
- Look for the profile and length on the back of the belt. For this belt, the profile is XPC and the length is 2650 mm. If the old belt is worn or the marking is unreadable, measure the drive or send photos of the sheaves and the belt.
- Should I replace all belts on the drive at once?
- On a multi-belt drive, replacing the full set at the same time helps keep tension even across the belts. Mixing new and old belts can cause the new belt to carry more load than the others.
- What should I check on the sheaves before fitting this belt?
- Inspect the grooves for wear, cracks, or buildup, and check alignment between the sheaves. Clean any oil or grease from the grooves. Correcting sheave problems before fitting a new belt helps avoid premature failure.