V-belt Movendis PP-XPB2000-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPB
- Series
- PowerPlus EPDM Cogged Raw Edge Narrow
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-XPB2000-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-XPB2000-EPDM-AS and any equivalents.
The Movendis PP-XPB2000-EPDM-AS is a cogged narrow V-belt in the XPB profile with a 2000 mm length. It is the belt to reach for when the drive calls for an XPB section and that exact length. Match both numbers to the belt you are replacing before you order.
The most reliable way to match a belt is to read the marking on the back of the old one. Confirm the profile is XPB and the length is 2000 mm, then compare that to the PP-XPB2000-EPDM-AS. If the old belt is worn, frayed or stretched, the marking may be hard to read; in that case, measure the drive or check the equipment manual for the original specification.
This is a cogged narrow V-belt, also called a wedge belt, with a raw edge construction. Cogged narrow V-belts are used where a standard wrapped belt would run too hot or slip under load. The XPB profile and 2000 mm length are the two dimensions that matter for fit. If your drive was built for an XPB section, this belt is the correct cross-section.
When you request a quote, send the part number PP-XPB2000-EPDM-AS and the quantity you need. If you are replacing more than one belt on the same drive, list every position so we can confirm the set. Our team can help verify the right belt or suggest an equivalent when the original marking is unclear.
Dimensions
- Section
- XPB
- Length
- 2000mm
Frequently asked questions
- How do I confirm this is the right belt for my drive?
- Check the marking on the back of the belt you are replacing. It should show an XPB profile and a 2000 mm length. If those match, the PP-XPB2000-EPDM-AS is the correct belt.
- What if the marking on my old belt is unreadable?
- Measure the drive or consult the equipment manual for the original belt specification. Send us the machine details and any photos of the drive, and we can help identify the correct profile and length.
- Can I order this belt for a multi-belt drive?
- Yes. Provide the number of belts you need for the drive. When replacing belts on a multi-belt drive, it is good practice to replace the full set so all belts wear evenly.