V-belt Movendis PP-XPA1140-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPA
- Series
- PowerPlus EPDM Cogged Raw Edge Narrow
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-XPA1140-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-XPA1140-EPDM-AS and any equivalents.
The Movendis PP-XPA1140-EPDM-AS is a cogged narrow V-belt in the XPA profile with a length of 1140 mm. It belongs to the PowerPlus EPDM Cogged Raw Edge Narrow series. To match it to the belt being replaced, compare the profile and the length marked on the old belt.
Before you request a quote, read the marking on the back of the belt you are replacing. The profile must be XPA and the length must be 1140 mm. If the old belt shows a different profile or length, that belt is not this one, even if the drive looks similar. The raw edge and cogged construction are part of this series, so the profile and length are the key fields to confirm.
When the marking is worn or unreadable, measure the outside length and check the cross-section against the XPA profile. Do not substitute a belt by appearance alone. The part number PP-XPA1140-EPDM-AS identifies the exact belt we carry. Send that number, or the profile and length you measured, and our team will confirm the right belt or suggest an equivalent.
For drives that use more than one belt, replace the full set at the same time so the belts share the load evenly. Inspect the pulleys for wear, alignment and debris before installation. A worn pulley can shorten the life of a new belt, so correct any drive issue before you put the new belt into service.
Dimensions
- Section
- XPA
- Length
- 1140mm
Frequently asked questions
- How do I confirm this is the belt I need?
- Check the marking on the back of your old belt. It should show the XPA profile and a length of 1140 mm. If it does, this belt matches. If the marking is unreadable, measure the length and compare the cross-section to the XPA profile.
- What should I send to get a quote?
- Send the part number PP-XPA1140-EPDM-AS, or the profile and length from the old belt, by WhatsApp or email. Our team will reply promptly to confirm the belt or suggest an equivalent.
- Can I replace just one belt on a multi-belt drive?
- It is best to replace all belts on the drive as a set. Belts that have run together wear at the same rate, and mixing old and new belts can cause uneven loading.